NETGEAR ProSAFE M7100-24X - Passwords Lock-Out; Passwords Strength-Check

Management Commands
524
ProSAFE M7100 Managed Switches
no passwords aging
Use this command to set the password aging to the default value.
passwords lock-out
Use this command to strengthen the security of the switch by locking user accounts that have
failed login due to wrong passwords. When a lockout count is configured, a user that is logged in
must enter the correct password within that count. Otherwise the user will be locked out from
further switch access. Only a user with read/write access can reactivate a locked user account.
Password lockout does not apply to logins from the serial console. The valid range is 1-5. The
default is 0, or no lockout count enforced.
no passwords lock-out
Use this command to set the password lock-out count to the default value.
passwords strength-check
Use this command to enable the password strength feature. It is used to verify the strength of a
password during configuration.
no passwords strength-check
Use this command to disable the password strength-check.
Format
no passwords aging
Mode Global Config
Default 0
Format passwords lock-out <1-5>
Mode Global Config
Format no passwords lock-out
Mode Global Config
Default Disable
Format passwords strength-check
Mode Global Config
Format no passwords strength-check
Mode Global Config