Utility Commands
395
ProSAFE M7100 Managed Switches
no logging email
This command disables email alerting.
logging email urgent
This command sets the lowest severity level at which log messages are emailed immediately in a
single email message. You can specify the <severitylevel> parameter either as an integer
from 0 to 7 or symbolically through one of the following keywords: emergency (0), alert (1),
critical (2), error (3), warning (4), notice (5), info (6), or debug (7). Specify none
to indicate that log messages are collected and sent in a batch email at a specified interval.
no logging email urgent
This command resets the urgent severity level to the default value.
logging email message-type to-addr
This command configures the email address to which messages are sent. The message types
supported are urgent, non-urgent, and both. For each supported severity level, multiple
email addresses can be configured. The to-email-addr variable is a standard email address, for
example admin@yourcompany.com.
no logging email message-type to-addr
This command removes the configured to-addr field of email.
Format no logging email
Mode Global Config
Default Alert (1) and emergency (0) messages are sent immediately
Format logging email urgent {<severitylevel> | none}
Mode Global Config
Format no logging email urgent
Mode Global Config
Format logging email message-type {urgent | non-urgent | both}
to-addr <to-email-addr>
Mode Global Config
Format no logging email message-type {urgent | non-urgent | both}
to-addr <to-email-addr>
Mode Global Config
To Next Page
Loading...
Need help?
General