Switching Commands
112
ProSAFE M7100 Managed Switches
no set igmp fast-leave
This command disables IGMP Snooping fast-leave admin mode on a selected interface.
set igmp groupmembership-interval
This command sets the IGMP Group Membership Interval time on a VLAN, one interface, or all
interfaces. The Group Membership Interval time is the amount of time in seconds that a switch
waits for a report from a particular group on a particular interface before deleting the interface
from the entry. This value must be greater than the IGMPv3 Maximum Response time value. The
range is 2–3600 seconds.
Default disabled
Format set igmp fast-leave
Mode Interface Config
Format set igmp fast-leave <vlan_id>
Mode VLAN Config
Format no set igmp fast-leave
Mode Interface Config
Format no set igmp fast-leave <vlan_id>
Mode VLAN Config
Default 260 seconds
Format set igmp groupmembership-interval <2-3600>
Mode • Int
erface Config
• Global Config
F
ormat set igmp groupmembership-interval <vlan_id> <2-3600>
Mode VLAN Config
To Next Page
Loading...
