NETGEAR ProSAFE M7100-24X - Telnetcon Maxsessions

Management Commands
504
ProSAFE M7100 Managed Switches
no session-limit
Use this command to set the maximum number of simultaneous outbound Telnet sessions to the
default v
alue.
session-timeout
Use this command to set the Telnet session timeout value. The timeout value unit of time is
minutes.
no session-timeout
Use this command to set the Telnet session timeout value to the default. The timeout value unit
of time is minutes.
telnetcon maxsessions
Use this command to specify the maximum number of Telnet connection sessions that can be
established. A value of 0 indicates that no Telnet connection can be established. The range is 0-5.
no telnetcon maxsessions
Use this command to set the maximum number of Telnet connection sessions that can be
established to the default value.
Format no session-limit
Mode Line Config
Default 5
Format session-timeout <1-160>
Mode Line Config
Format no session-timeout
Mode Line Config
Default 4
Format telnetcon maxsessions <0-4>
Mode Privileged EXEC
Format no telnetcon maxsessions
Mode Privileged EXEC