NETGEAR ProSAFE M7100-24X - Show Policy-Map Interface; Show Service-Policy

Quality of Service (QoS) Commands
249
ProSAFE M7100 Managed Switches
show policy-map interface
This command displays policy-oriented statistics information for the specified interface and
direction. The <slot/port> parameter specifies a valid interface for the system.
Note: This command is only allowed while the DiffServ administrative mode is
enabled.
The following information is repeated for each class instance within this policy:
show service-policy
This command displays a summary of policy-oriented statistics information for all interfaces in
the specified direction.
The following information is repeated for each interface and direction (only those interfaces
configur
ed with an attached policy are shown):
Format show policy-map interface <slot/port> [in | out]
Mode Privileged EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes.
Direction The traffic direction of this interface service.
Operational
S
t
atus
The current operational status of this DiffServ service interface.
Policy Name The name of the policy attached to the interface in the indicated direction.
Term Definition
Class Name The name of this class instance.
In Discarded
Pack
ets
A count of the packets discarded for this class instance for any reason due to DiffServ
treatment of the traffic class.
Format show service-policy {in | out}
Mode Privileged EXEC