NETGEAR ProSAFE M7100-24X - Auto-Voip Oui; Auto-Voip Vlan; Auto-Voip Oui-Based Priority

Quality of Service (QoS) Commands
273
ProSAFE M7100 Managed Switches
auto-voip oui
This command is used to configure an OUI for Auto VoIP. The traffic from the configured OUI will
get the highest priority over the other traffic.
no auto-voip oui
This command is to delete already configured OUI.
auto-voip vlan
This command is used to configure the global Auto VoIP VLAN id. The VLAN behavior depends on
the configured auto VoIP mode.
no auto-voip vlan
This command is used to set the auto-voip VLAN to the default 2.
auto-voip oui-based priority
This command is used to configure the global OUI based auto VoIP priority. If the phone OUI is
matches one of the configured OUI, the priority of traffic from the phone is changed to OUI
priority configured through this command.
Default A list of known OUIs is present
Format auto-voip oui <oui-prefix> oui-desc <string>
Mode Global Config
Format no auto-voip oui <oui-prefix>
Mode Global Config
Default None
Format auto-voip vlan <vlanid>
Mode Global Config
Format no auto-voip vlan
Mode Global Config
Default Highest available priority
Format auto-voip oui-based priority <priority-value>
Mode Global Config