NETGEAR ProSAFE M7100-24X - Ip Irdp Minadvertinterval; Ip Irdp Preference; Show Ip Irdp

Routing Commands
197
ProSAFE M7100 Managed Switches
ip irdp minadvertinterval
This command configures the minimum time, in seconds, allowed between sending router
advertisements from the interface. The range for minadvertinterval is three to the value of
maxadvertinterval.
no ip irdp minadvertinterval
This command sets the default minimum time to the default.
ip irdp preference
This command configures the preferability of the address as a default router address, relative to
other router addresses on the same subnet.
no ip irdp preference
This command configures the default preferability of the address as a default router address,
relative to other router addresses on the same subnet.
show ip irdp
This command displays the router discovery information for all interfaces, or a specified
interface.
Default 0.75 * maxadvertinterval
Format ip irdp minadvertinterval <3-maxadvertinterval>
Mode Interface Config
Format no ip irdp minadvertinterval
Mode Interface Config
Default 0
Format ip irdp preference <-2147483648 to 2147483647>
Mode Interface Config
Format no ip irdp preference
Mode Interface Config
Format show ip irdp {<slot/port> | all}
Modes • P
rivileged EXEC
• User EXEC