Utility Commands
393
ProSAFE M7100 Managed Switches
show logging persistent
Use the show logging persistent command to display persistent log entries.
show logging traplogs
This command displays SNMP trap events and statistics.
Term Definition
Host Index (Used for deleting hosts.)
IP Address /
Hostname
IP addr
ess or hostname of the logging host.
Severity Level The minimum severity to log to the specified address. The possible values are emergency (0),
alert (1), critic
al (2), error (3), warning (4), notice (5), info (6), or debug (7).
Port The server port number, which is the port on the local host from which syslog messages are
sent.
Hos
t Status The state of logging to configured syslog hosts. If the status is disable, no logging occurs.
Format show logging persistent
Mode Privileged EXEC
Term Definition
Persistent
Logging
Shows whe
ther persistent logging is enabled.
Persistent Log
Count
The number of persis
tent log entries.
Format show logging traplogs
Mode Privileged EXEC
Term Definition
Number of Traps
Since Las
t Reset
The number of traps since the last boot.
Trap Log Capacity The number of traps the system can retain.
Number of Traps
Sinc
e L
og Last
Viewed
The number of new traps since the command was last executed.
Log The log number.
To Next Page
Loading...
