Log Messages
609
ProSAFE M7100 Managed Switches
Multicast
Table 51. RIP Log Message
Component Message Cause
RIP RIP : discard response from xxx via
unexpec
ted interface
When RIP response is received with a source
address not matching the incoming
interface’s subnet.
Table 52. DHCP6 Log Message
Component Message Cause
DHCP6 relay_to_server: Cannot relay to relay server
intf x
xx: not IPv6 enabled
Relay is enabled but neither the outgoing
interface nor the server IP address is
specified.
Table 53. Cache Log Messages
Component Message Cause
Cache Out of memory when creating entry. When we run out of memory while creating a
new cache (MFC) entr
y
Cache Out of memory when creating cache. When we run out of memory while creating
the cache itself
Table 54. IGMP Log Messages
Component Message Cause
IGMP Error creating IGMP pipe
Error opening IGMP pipe
When we fail to create / open IGMP pipe for
Mcas
t control messages
IGMP Error creating IGMP data pipe
Error opening IGMP data pipe
When we fail to create / open IGMP data pipe
f
or Mc
ast data messages
IGMP Error getting memory for source record When we are unable to allocate memory for a
sour
c
e record in the received IGMP V3
report
IGMP Failed getting memory for new group When we are unable to allocate memory for a
gr
oup r
ecord in the received IGMP
V3/V2/V1 report
To Next Page
Loading...
Need help?
General