NETGEAR ProSAFE M7100-24X - Clear Green-Mode Statistics; Show Green-Mode (for an Interface)

Green Ethernet Commands
584
ProSAFE M7100 Managed Switches
clear green-mode statistics
This command clears the following for a specified slot and port, or for all ports:
• EEE LPI event c
ount, and LPI duration
• EEE LPI hist
ory table entries
• Cumulative Power savings estimates
Ex
ample
(switch) #clear green-mode statistics 0/1
Are you sure you want to clear the green mode port stats? (y/n)y
Green Mode Stats Cleared.
(switch) #clear green-mode statistics all
Are you sure you want to clear the green mode port stats? (y/n)y
Green Mode Stats Cleared.
show green-mode (for an interface)
This command displays green mode configuration and operational status of a port. This command
can also display the per port configuration and operational status of the green-mode. The status
is shown only for the modes supported on the switch.
Format clear green-mode statistics {<slot/port> | all}
Mode Privileged Exec
Format show green-mode <slot/port>
Mode Privileged Exec
Term Definition
EEE Admin Mode EEE Admin Mode is enabled or disabled.
Transmit Idle Time It is the time for which condition to move to LPI state is satisfied, at the end of which
MAC T
X transitions to LPI state. The Range is (0 to 0xffffffff).The default value is 0.
Transmit Wake Time It is the time for which MAC / switch has to wait to go back to ACTIVE state from LPI
st
ate when it receives packet for transmission. The Range is (0 to 0xffff).The default
value is 0.
Rx Low Power Idle Event
C
ount
This field is incr
emented each time MAC RX enters LP IDLE state. Shows the total
number of Rx LPI Events since EEE counters are last cleared
Rx Low Power Idle
Duration (micr
osec)
This field indicates duration of Rx LPI state in 10-microsecond increments. Shows the
total duration of Rx LPI since the EEE counters are last cleared.
Tx Low Power Idle Event
Count
This field is incr
emented each time MAC TX enters LP IDLE state. Shows the total
number of Tx LPI Events since EEE counters are last cleared.
Tx Low Power Idle
Duration (micr
osec)
This field indicates duration of Tx LPI state in 10us increments. Shows the total
duration of Tx LPI since the EEE counters are last cleared.