Routing Commands
177
ProSAFE M7100 Managed Switches
show arp switch
This command displays the contents of the switch’s Address Resolution Protocol (ARP) table.
IP Routing Commands
This section describes the commands you use to enable and configure IP routing on the switch.
routing
This command enables IPv4 and IPv6 routing for an interface. You can view the current value for
this function with the show ip brief command. The value is labeled as “Routing Mode.”
Term Definition
Age Time
(seconds)
The time it t
akes for an ARP entry to age out. This value is configurable. Age time is measured
in seconds.
Response Time
(seconds)
The time it t
akes for an ARP request timeout. This value is configurable. Response time is
measured in seconds.
Retries The maximum number of times an ARP request is retried. This value is configurable.
Cache Size The maximum number of entries in the ARP table. This value is configurable.
Dynamic Renew
Mode
Displays whether the ARP component automatically attempts to renew dynamic ARP entries
when the
y age out
.
Total Entry Count
Cur
rent / Peak
The total entries in the ARP table and the peak entry count in the ARP table.
Static Entry
Count C
urrent /
Max
The static entry count in the ARP table and maximum static entry count in the ARP table.
Format show arp switch
Mode Privileged EXEC
Term Definition
IP Address The IP address of a device on a subnet attached to the switch.
MAC Address The hardware MAC address of that device.
Interface The routing slot/port associated with the device’s ARP entry.
Default disabled
Format routing
Mode Interface Config
To Next Page
Loading...
