Switching Commands
80
ProSAFE M7100 Managed Switches
lacp partner admin state individual
Use this command to set LACP partner admin state to individual.
Note: This command is only applicable to physical interfaces.
no lacp partner admin state individual
Use this command to set the LACP partner admin state to aggregation.
lacp partner admin state longtimeout
Use this command to set LACP partner admin state to longtimeout.
Note: This command is only applicable to physical interfaces.
no lacp partner admin state longtimeout
Use this command to set the LACP partner admin state to short timeout.
Note: This command is only applicable to physical interfaces.
Format lacp partner admin state individual
Mode Interface Config
Format no lacp partner admin state individual
Mode Interface Config
Format lacp partner admin state longtimeout
Mode Interface Config
Format no lacp partner admin state longtimeout
Mode Interface Config
To Next Page
Loading...
