NETGEAR ProSAFE M7100-24X - Utilities

Log Messages
592
ProSAFE M7100 Managed Switches
Utilities
Table 11. System Log Messages
Component Message Cause
SYSTEM Configuration file Switch CLI.cfg size is 0
(zer
o) bytes
The configuration file could not be read. This
message might occur on a system for which
no configuration has ever been saved or for
which configuration has been erased.
SYSTEM could not separate
SY
SAPI_C
ONFIG_FILENAME
The configuration file could not be read. This
message might occur on a system for which
no configuration has ever been saved or for
which configuration has been erased.
SYSTEM Building defaults for file <file name> version
<v
ersion num>
C
onfiguration did not exist or could not be
read for the specified feature or file. Default
configuration values will be used. The file
name and version are indicated.
SYSTEM File <filename>: same version (version num)
but the siz
es (<v
ersion size>-><expected
version size) differ
The configuration file which was loaded was
of a different size than expected for the
version number. This message indicates the
configuration file needed to be migrated to
the version number appropriate for the code
image. This message might appear after
upgrading the code image to a more current
release.
SYSTEM Migrating config file <filename> from
v
ersion <v
ersion num> to <version num>
The configuration file identified was migrated
from a previous version number. Both the old
and new version number are specified. This
message might appear after upgrading the
code image to a more current release.
SYSTEM Building Defaults Configuration did not exist or could not be
r
e
ad for the specified feature. Default
configuration values will be used.
SYSTEM sysapiCfgFileGet failed size = <expected size
of file> v
ersion = <e
xpected version>
Configuration did not exist or could not be
read for the specified feature. This message
is usually followed by a message indicating
that default configuration values will be used.
Table 12. Trap Mgr Log Message
Component Message Cause
Trap Mgr Link Up/Down: slot/port An interface changed link state.