Switching Commands
50
ProSAFE M7100 Managed Switches
no vlan ingressfilter
This command disables ingress filtering. If ingress filtering is disabled, frames received with VLAN
IDs that do not mat
ch the VLAN membership of the receiving interface are admitted and
forwarded to ports that are members of that VLAN.
vlan internal allocation
Use this command to configure which VLAN IDs are used for port-based routing interfaces. When
a port-based routing interface is created, an unused VLAN ID is assigned internally.
vlan makestatic
This command changes a dynamically created VLAN (one that is created by GVRP registration) to
a static VLAN (one that is permanently configured and defined). The ID is a valid VLAN
identification number. VLAN range is 2-4093.
vlan name
This command changes the name of a VLAN. The name is an alphanumeric string of up to 32
characters, and the ID is a valid VLAN identification number. ID range is 1-4093.
Format no vlan ingressfilter
Mode Interface Config
Format vlan internal allocation {base <vlan-id> | policy ascending | policy
decending}
Mode Global Config
Parameter Description
base vlan-id The first VLAN ID to be assigned to a port-based routing interface.
policy ascending The VLAN IDs that are assigned to port-based routing interfaces start at the base VLAN ID
and incre
ase in value.
policy descending The VLAN IDs that are assigned to port-based routing interfaces start at the base VLAN ID
and decre
ase in value.
Format vlan makestatic <2-4093>
Mode VLAN Config
Default • VLAN ID 1 - default
• other VLANS - blank string
F
ormat vlan name <1-4093> <name>
Mode VLAN Config
To Next Page
Loading...
