Security Commands
318
ProSAFE M7100 Managed Switches
Static MAC Filtering Commands
The commands in this section describe how to configure static MAC filtering. Static MAC filtering
allows you to configure destination ports for a static multicast MAC filter irrespective of the
platform.
macfilter
This command adds a static MAC filter entry for the MAC address <macaddr> on the VLAN
<vlanid>. The value of the <macaddr> parameter is a 6-byte hexadecimal number in the
format of b1:b2:b3:b4:b5:b6. The following MAC addresses are restricted: 00:00:00:00:00:00,
01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and
FF:FF:FF:FF:FF:FF. The <vlanid> parameter must identify a valid VLAN.
The number of static mac filters supported on the system is different for MAC filters where
sour
c
e ports are configured and MAC filters where destination ports are configured.
• For unicast MAC address filters and multicast MAC address filters with source port lists, the
maximum number of static MAC filters supported is 20.
• For multicast MAC address filters with destination ports configured, the maximum number of
s
tatic filters supported is 256.
For example, for current platforms you can configure the following combinations:
• Unicast MAC and source port (max = 20)
•
Multicast MAC and source port (max=20)
•
Multicast MAC and destination port (only) (max=256)
•
Multicast MAC and source ports and destination ports (max=20)
no mac
filter
This command removes all filtering restrictions and the static MAC filter entry for the MAC
addres
s <macaddr> on the VLAN <vlanid>. The <macaddr> parameter must be specified as
a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The <vlanid> parame
ter must identify a valid VLAN.
Format macfilter <macaddr> <vlanid>
Mode Global Config
Format no macfilter <macaddr> <vlanid>
Mode Global Config
To Next Page
Loading...
Need help?
General