NETGEAR ProSAFE M7100-24X - DHCP Snooping Configuration Commands; Ip Dhcp Snooping Vlan; Ip Dhcp Snooping Verify Mac-Address

Security Commands
329
ProSAFE M7100 Managed Switches
DHCP Snooping Configuration Commands
This section describes commands you use to configure DHCP Snooping.
ip dhcp snooping
Use this command to enable DHCP Snooping globally.
no ip dhcp snooping
Use this command to disable DHCP Snooping globally.
ip dhcp snooping vlan
Use this command to enable DHCP Snooping on a list of comma-separated VLAN ranges.
no ip dhcp snooping vlan
Use this command to disable DHCP Snooping on VLANs.
ip dhcp snooping verify mac-address
Use this command to enable verification of the source MAC address with the client hardware
address in the received DCHP message.
Default disabled
Format ip dhcp snooping
Mode Global Config
Format no ip dhcp snooping
Mode Global Config
Default disabled
Format ip dhcp snooping vlan <vlan-list>
Mode Global Config
Format no ip dhcp snooping vlan <vlan-list>
Mode Global Config
Default enabled
Format ip dhcp snooping verify mac-address
Mode Global Config