Routing Commands
198
ProSAFE M7100 Managed Switches
Virtual LAN Routing Commands
This section describes the commands you use to view and configure VLAN routing and to view
VLAN routing status information.
vlan routing
This command enables routing on a VLAN. The vlanid value has a range from 1 to 4093. The
<interface ID> value has a range from 1 to 128. Typically, you will not supply the interface
ID argument, and the system automatically selects the interface ID. However, if you specify an
interface ID that is already in use, the CLI displays an error message and does not create the VLAN
interface.
no vlan routing
This command deletes routing on a VLAN. The <vlanid> v
alue has a r
ange from 1 to 4093.
Term Definition
Interface The <slot/port> that matches the r
est of the information in the row.
Ad Mode The advertise mode, which indicates whether router discovery is enabled or disabled on this
inter
face.
Advertise Address The IP address to which the interface sends the advertisement.
Max Int The maximum advertise interval, which is the maximum time, in seconds, allowed between
sending r
out
er advertisements from the interface.
Min Int The minimum advertise interval, which is the minimum time, in seconds, allowed between
sending rout
er advertisements from the interface.
Hold Time The amount of time, in seconds, that a system should keep the router advertisement before
discar
ding it.
Preference The preference of the address as a default router address, relative to other router addresses
on the same subnet
.
Format vlan routing <vlanid> [<interface ID>]
Mode VLAN Config
Format no vlan routing <vlanid>
Mode VLAN Config
To Next Page
Loading...
