Security Commands
316
ProSAFE M7100 Managed Switches
no storm-control unicast
This command disables unicast storm recovery mode for all interfaces.
storm-control unicast level (Global)
This command configures the unicast storm recovery threshold for all interfaces as a percentage
of link speed, and enables unicast storm recovery. If the mode is enabled, unicast storm recovery
is active, and if the rate of unknown L2 unicast (destination lookup failure) traffic ingressing on
an interface increases beyond the configured threshold, the traffic will be dropped. Therefore,
the rate of unknown unicast traffic will be limited to the configured threshold.
no storm-control unicast level
This command sets the unicast storm recovery threshold to the default value and disables unicast
s
t
orm recovery for all interfaces.
storm-control unicast rate (Global)
Use this command to configure the unicast storm recovery threshold for all interfaces in packets
per second. If the mode is enabled, unicast storm recovery is active, and if the rate of L2
broadcast traffic ingressing on an interface increases beyond the configured threshold, the
traffic is dropped. Therefore, the rate of unicast traffic is limited to the configured threshold.
Format no storm-control unicast
Mode Global Config
Default 5
Format storm-control unicast level <0-100>
Mode Global Config
Format no storm-control unicast level
Mode Global Config
Default 0
Format storm-control unicast rate <0-14880000>
Mode Global Config
To Next Page
Loading...
