Utility Commands
418
ProSAFE M7100 Managed Switches
no clock timezone
This command sets the switch to UTC time.
clock set
This command sets the system time and date.
clock summer-time recurring
Use the clock summer-time recurring command to set the summertime offset to UTC recursively
every year. If the optional parameters are not specified, they are read as either '0' or '\0', as
appropriate.
Use the following parameters to configure the summer-time.
• USA—the US Daylight saving time setting is used (Start --- March, 2nd sunday 02:00 AM,
End --- Nov, 1st sunday, 2:00 AM)
• EU—the Eur
opean Union Daylight savings time is used (Start --- March, 5th Sunday 02:00
AM, End --- October, 5th Sunday, 3:00 AM)
• week—Week of the month. (Range: 1-5, first, last)
•
day—Day of the week
. (Range: The first three letters by name; sun, for example.)
• month—Month. (Range: The first three le
tters by name; jan, for example.)
• hh:mm—Time in 24-hour f
ormat in hours and minutes. (Range: hh:0-23, mm: 0-59)
• offset—Number of minutes to add during the summertime. (Range:1-1440)
•
acronym—The acronym for the time zone to be displayed when summertime is in effect.
(Range: Up t
o four characters)
Example:
(Switch)(Config)# clock summer-time recurring 1 sun jan
00:10 2 mon mar 10:00 offset 1 zone ABC
Format no clock timezone
Mode Global Config
Format clock set {<hh:mm:ss> | <mm/dd/yyyy>}
Mode Global Config
Format clock summer-time recurring {USA | EU | <week> <day> <month>
<hh:mm> <week> <day> <month> <hh:mm>} [offset <offset> ] [zone
<zone-acronym>]
Mode Global Config
To Next Page
Loading...
Need help?
General