Switching Commands
76
ProSAFE M7100 Managed Switches
deleteport (Global Config)
This command deletes all configured ports from the port-channel (LAG). The interface is a logical
slot/port number of a configured port-channel. To clear the port channels, see clear
port-channel on page 405
.
lacp admin key
Use this command to configure the administrative value of the key for the port-channel. The
value range of <key> is 0–65535.
Note: This command is only applicable to port-channel interfaces.
no lacp admin key
Use this command to configure the default administrative value of the key for the port-channel.
lacp collector max-delay
Use this command to configure the port-channel collector max delay. The valid range of
<delay> is 0-65535.
Note: This command is only applicable to port-channel interfaces.
Format deleteport <logical slot/port>
Mode Global Config
Default 0x8000
Format lacp admin key <key>
Mode Interface Config
Format no lacp admin key
Mode Interface Config
Default 0x8000
Format lacp collector max-delay <delay>
Mode Interface Config
To Next Page
Loading...
Need help?
General