Security Commands
350
ProSAFE M7100 Managed Switches
port-security mac-address sticky
This command enables sticky mode Port MAC Locking on a port. If accompanied by a MAC
address and a VLAN id (for interface config mode only), it adds a sticky MAC address to the list of
statically locked MAC addresses. These sticky addresses are converted back to dynamically
locked addresses if sticky mode is disabled on the port. The <vid> is the VLAN ID. The Global
command applies the sticky mode to all valid interfaces (physical and LAG). There is no global
sticky mode as such.
Sticky addresses that are dynamically learned will appear in show running config as
port-security mac-address sticky <mac> <vid> entries. This dis
tinguishes them
fr
om static entries.
no port-security mac-address sticky
The no form removes the sticky mode. The sticky MAC address can be deleted by using the
c
ommand
no port-security mac-address sticky <mac> <vid>.
show port-security
This command displays the port-security settings. If you do not use a parameter, the command
displays the settings for the entire system. Use the optional parameters to display the settings on
a specific interface or on all interfaces.
For each interface, or for the interface you specify, the following information appears:
Format port-security mac-address sticky [<mac-address> <vid>]
Modes • Global Config
• Interface Config
F
ormat no port-security mac-address sticky [<mac-address> <vid>]
Modes • Global Config
• Interface Config
F
ormat show port-security [{<slot/port> | all}]
Mode Privileged EXEC
Term Definition
Admin Mode Port Locking mode for the entire system. This field displays if you do not supply any
parame
ters.
Term Definition
Admin Mode Port Locking mode for the Interface.
Dynamic Limit Maximum dynamically allocated MAC Addresses.
To Next Page
Loading...
