NETGEAR ProSAFE M7100-24X - Terminal Display Commands; Terminal Length

Management Commands
580
ProSAFE M7100 Managed Switches
Terminal Display Commands
Terminal displays commands let you configure the pagination length and number of lines of
output to be displayed on the screen for Telnet, SSH, and console sessions.
length
Use this command to set the pagination length to value number of lines for the sessions specified
by configuring on different Line Config modes (Telnet, SSH, and console) and is persistent. Enter
0 to specify no pagination.
no length value
Use this command to set the pagination length to the default value number of lines.
terminal length
Use this command to set the number of lines of output to be displayed on the screen, that is, the
pagination, for the show running-config and show running-config all commands.
The terminal length size is either zero or a number in the range of 5–48. After the
user-configured number of lines is displayed in one page, the system prompts the user
“--More-- or (q)uit.” Press q or Q to quit, or press any key to display the next set of
<5-48> lines. The command terminal length 0 disables pagination and, as a result, the
output of the show running-config command is displayed immediately.
no terminal length
Use this command to set the terminal length to the default value.
Default 24
Format length {0 | <5-48>}
Mode Line Config
Format no length
Mode Line Config
Default 24 lines per page
Format terminal length {0 | <5-48>}
Mode Privileged EXEC
Format no terminal length
Mode Privileged EXEC