NETGEAR ProSAFE M7100-24X - Set Igmp Maxresponse

Switching Commands
113
ProSAFE M7100 Managed Switches
no set igmp groupmembership-interval
This command sets the IGMPv3 Group Membership Interval time to the default value.
set igmp maxresponse
This command sets the IGMP Maximum Response time for the system, or on a particular
interface or VLAN. The Maximum Response time is the amount of time in seconds that a switch
will wait after sending a query on an interface because it did not receive a report for a particular
group in that interface. This value must be less than the IGMP Query Interval time value. The
range is 1–25 seconds.
no set igmp maxresponse
This command sets the max response time (on the interface or VLAN) to the default value.
Format no set igmp groupmembership-interval
Mode • Interface Config
• Global Config
F
ormat no set igmp groupmembership-interval <vlan_id>
Mode VLAN Config
Default 10 seconds
Format set igmp maxresponse <1-25>
Mode • Global C
onfig
• Interface Config
F
ormat set igmp maxresponse <vlan_id> <1-25>
Mode VLAN Config
Format no set igmp maxresponse
Mode • Global C
onfig
• Interface Config
Format no set igmp maxresponse <vlan_id>
Mode VLAN Config