Security Commands
325
ProSAFE M7100 Managed Switches
no arp access-list
Use this command to delete a configured ARP ACL.
permit ip host mac host
Use this command to configure a rule for a valid IP address and MAC address combination used in
ARP packet validation.
no permit ip host mac host
Use this command to delete a rule for a valid IP and MAC combination.
show ip arp inspection
Use this command to display the Dynamic ARP Inspection global configuration and configuration
on all the VLANs. With the <vlan-list> argument (that is, comma-separated VLAN ranges),
the command displays the global configuration and configuration on all the VLANs in the given
VLAN list. The global configuration includes the source mac validation, destination mac validation,
and invalid IP validation information.
Format no arp access-list <acl-name>
Mode Global Config
Format permit ip host <sender-ip> mac host <sender-mac>
Mode ARP Access-list Config
Format no permit ip host <sender-ip> mac host <sender-mac>
Mode ARP Access-list Config
Format show ip arp inspection [vlan <vlan-list>]
Mode • P
rivileged EXEC
• User EXEC
Term Definition
Source MAC
Validation
Display
s whether Source MAC Validation of ARP frame is enabled or disabled.
Destination MAC
Validation
Display
s whether Destination MAC Validation is enabled or disabled.
IP Address
Validation
Display
s whether IP Address Validation is enabled or disabled.
VLAN The VLAN ID for each displayed row.
To Next Page
Loading...
Need help?
General