NETGEAR ProSAFE M7100-24X - Logging Host Reconfigure; Show Logging Buffered; Show Logging Hosts

Utility Commands
392
ProSAFE M7100 Managed Switches
logging host reconfigure
This command lets you reconfigure the IP address of a configured syslog host. You must enter the
logging host index and either the host IP address or the host name.
show logging buffered
This command displays buffered logging (system startup and system operation logs).
show logging hosts
This command displays all configured logging hosts.
Log Messages
Received
Number of messages received by the log process. This includes messages that are dropped or
ignored.
Log Messages
Dropped
Number of mes
sages that could not be processed due to error or lack of resources.
Log Messages
Relayed
Number of mes
sages sent to the collector/relay.
Format logging host reconfigure <hostindex> {<hostaddress> | <hostname>}
Mode Privileged EXEC
Format show logging buffered
Mode Privileged EXEC
Term Definition
Buffered
(In-Memor
y)
Logging
Shows whether the In-Memory log is enabled or disabled.
Buffered Logging
Wr
apping
Behavior
The behavior of the In Memory log when faced with a log full situation.
Buffered Log
Count
The c
ount of valid entries in the buffered log.
Format show logging hosts
Mode Privileged EXEC
Term Definition