Switching Commands
103
ProSAFE M7100 Managed Switches
no monitor session
This command removes a specified mirrored port from the session. The <session-id> parameter
is an integer v
alue that is used to identify the session. However, you always need to enter 1 for
the <session-id> parameter.
no monitor
This command removes all the source ports and the destination port and restores the default
value f
or the mirroring session mode for all the configured sessions.
show monitor session
This command displays the port monitoring information for a particular mirroring session.
The <session-id> parameter is an integer value that is used to identify the session. However, you
alway
s need to enter 1 for the <session-id> parameter.
The CLI display output might include the following information:
Format no monitor session <session-id>
Mode Global Config
Default enabled
Format no monitor
Mode Global Config
Default You need to enter 1 for the <session-id> par
ame
ter.
Format show monitor session <session-id>
Mode Privileged EXEC
Term Definition
Session ID An integer value used to identify the session. You always need to enter 1.
Admin Mode Indicates whether the Port Mirroring feature is enabled or disabled for the session. The
possible v
alues are Enable and Disable.
Probe Port The probe port (destination port) for the session. If the probe port is not specified, this field
is blank.
Mir
rored Port The port that is configured as the mirrored port (source port) for the session
. If no source
port is configured for the session, this field is blank.
Type The direction in which the source port is configured for port mirroring. Types are tx for
transmitt
ed packets and rx for receiving packets.
Src VLAN All the member ports of the source VLAN are mirrored. If the source VLAN is not configured,
this field is blank.
To Next Page
Loading...
Need help?
General