NETGEAR ProSAFE M7100-24X - Show Ip Dhcp Binding; Show Ip Dhcp Global Configuration; Show Ip Dhcp Pool Configuration

Utility Commands
432
ProSAFE M7100 Managed Switches
show ip dhcp binding
This command displays address bindings for the specific IP address on the DHCP server. If no IP
address is specified, the bindings corresponding to all the addresses are displayed.
show ip dhcp global configuration
This command displays address bindings for the specific IP address on the DHCP server. If no IP
address is specified, the bindings corresponding to all the addresses are displayed.
show ip dhcp pool configuration
This command displays pool configuration. If all is specified, configuration for all the pools is
displayed.
Format show ip dhcp binding [<address>]
Modes • Privileged EXEC
• User EXEC
Term Definition
IP address The IP address of the client.
Hardware
Addres
s
The MAC Address or the client identifier.
Lease expiration The lease expiration time of the IP address assigned to the client.
Type The manner in which IP address was assigned to the client.
Format show ip dhcp global configuration
Modes • P
rivileged EXEC
• User EXEC
Term Definition
Service DHCP The field to display the status of dhcp protocol.
Number of Ping
Pack
ets
The maximum number of ping packets that are sent to verify that an IP address is not already
assigned.
Conflict Logging Shows whether conflict logging is enabled or disabled.
BootP Automatic Shows whether BootP for dynamic pools is enabled or disabled.
Format show ip dhcp pool configuration {<name> | all}
Modes • P
rivileged EXEC
• User EXEC