EasyManua.ls Logo

NETGEAR ProSAFE M7100-24X - Show Ip Protocols

NETGEAR ProSAFE M7100-24X
636 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Routing Commands
188
ProSAFE M7100 Managed Switches
show ip protocols
This command lists a summary of the configuration and status for each unicast routing protocol.
The command lists routing protocols that are configured and enabled. If a protocol is selected on
the command line, the display is limited to that protocol.
Format show ip protocols [ospf | rip]
Mode Privileged EXEC
Parameter Description
OSPFv2
Router ID The router ID configured for OSPFv2
OSPF Admin Mode Whether OSPF is enabled or disabled globally
Maximum Paths The maximum number of next hops in an OSPF route
Routing for
Netw
ork
s
The address ranges configured with an OSPF network command
Distance The administrative distance (or route preference) for intra-area, inter-area, and
ex
ternal routes
Default Route
Adver
tise
Whether OSPF is configured to originate a default route
Always Whether default advertisement depends on having a default route in the common
routing t
able
Metric The metric configured to be advertised with the default route
Metric Type The metric type for the default route
Redist Source A type of routes that OSPF is redistributing
Metric The metric to advertise for redistributed routes of this type
Metric Type The metric type to advertise for redistributed routes of this type
Subnets Whether OSPF redistributes subnets of classful addresses, or only classful prefixes
Dist List A distribute list used to filter routes of this type. Only routes that pass the distribute list
ar
e r
edistributed
Number of Active
Are
as
The number of OSPF areas with at least one interface running on this router. Also broken
down by area type
ABR Status Whether the router is an area border router. A router is an area border router if it has
inter
faces that are up in more than one area
ASBR Status Whether the router is an autonomous system boundary router. The router is an ASBR if it
is redis
tributing any routes or originating a default route
RIP
Split Horizon Mode Whether RIP advertises routes on the interface where they were received

Table of Contents

Other manuals for NETGEAR ProSAFE M7100-24X

Related product manuals