NETGEAR ProSAFE M7100-24X - Role Priority; Peer-Keepalive Timeout

Switching Commands
93
ProSAFE M7100 Managed Switches
role priority
This command configures the priority of the MLAG switch. This value of the priority is used for
the MLAG role election. The priority value is sent to the peer in the MLAG keep-alive messages.
The configurable range for priority is 1-255.
An MLAG switch with a lower priority becomes the primary switch and an MLAG switch with a
higher priority bec
omes the secondary switch. If both the MLAG peer switches have the same
role priority, the switch with the lower system MAC address becomes the primary switch.
Note: Even if the keep-alive priority is modified after the election of the
MLAG role, the keep-alive state machine is not restarted.
no role priority
This command resets the keep-alive priority to the default value of 100.
peer-keepalive timeout
This command configures the peer keep-alive timeout value in seconds. The configurable range
for the keep-alive timeout value is 2 to 15 seconds.
If an MLAG switch does not receive keep-alive messages from the peer when the timeout value is
exceeded, the MLAG switch might transition to another MLAG role.
Note: Even if the keep-alive priority is modified after the election of the
MLAG role, the keep-alive state machine is not restarted.
Default 100
Format role priority <value>
Mode VPC Domain Config
Format no role priority
Mode VPC Domain Config
Default 5 seconds
Format peer-keepalive timeout <value>
Mode VPC Domain Config