Security Commands
313
ProSAFE M7100 Managed Switches
no storm-control multicast
This command disables multicast storm recovery mode for all interfaces.
storm-control multicast level (Global)
This command configures the multicast storm recovery threshold for all interfaces as a
percentage of link speed and enables multicast storm recovery mode. If the mode is enabled,
multicast storm recovery is active, and if the rate of L2 multicast traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the
rate of multicast traffic will be limited to the configured threshold.
no storm-control multicast level
This command sets the multicast storm recovery threshold to the default value for all interfaces
and disables multic
as
t storm recovery.
storm-control multicast rate (Global)
Use this command to configure the multicast storm recovery threshold for all interfaces in
packets per second. If the mode is enabled, multicast storm recovery is active, and if the rate of
L2 broadcast traffic ingressing on an interface increases beyond the configured threshold, the
traffic is dropped. Therefore, the rate of multicast traffic is limited to the configured threshold.
Format no storm-control multicast
Mode Global Config
Default 5
Format storm-control multicast level <0-100>
Mode Global Config
Format no storm-control multicast level
Mode Global Config
Default 0
Format storm-control multicast rate <0-14880000>
Mode Global Config
To Next Page
Loading...
