Security Commands
332
ProSAFE M7100 Managed Switches
ip dhcp snooping log-invalid
Use this command to control the logging DHCP messages filtration by the DHCP Snooping
application.
no ip dhcp snooping log-invalid
Use this command to disable the logging DHCP messages filtration by the DHCP Snooping
application.
ip dhcp snooping trust
Use this command to configure the port as trusted.
no ip dhcp snooping trust
Use this command to configure the port as untrusted.
ip verify source
Use this command to configure the IPSG source ID attribute to filter the data traffic in the
hardware. Source ID is the combination of IP address and MAC address. Normal command allows
data traffic filtration based on the IP address. With the port-security option, the data traffic
is filtered based on the IP and MAC addresses.
Default disabled
Format ip dhcp snooping log-invalid
Mode Interface Config
Format no ip dhcp snooping log-invalid
Mode Interface Config
Default disabled
Format ip dhcp snooping trust
Mode Interface Config
Format no ip dhcp snooping trust
Mode Interface Config
Default The source ID is the IP address
Format ip verify source [port-security]
Mode Interface Config
To Next Page
Loading...
Need help?
General