NETGEAR ProSAFE M7100-24X - Storm-Control Commands; Dot1 X Supplicant Timeout Auth-Period; Dot1 X Supplicant User

Security Commands
307
ProSAFE M7100 Managed Switches
no dot1x supplicant timeout held-period
Use this command to set the held-period value to the default value.
dot1x supplicant timeout auth-period
Use this command to configure the authentication period timer interval to wait for the next EAP
request challenge from the authenticator. Specify the authentication period in seconds.
no dot1x supplicant timeout auth-period
Use this command to set the auth-period value to the default value.
dot1x supplicant user
Use this command to map the given user to the port.
Storm-Control Commands
This section describes commands you use to configure storm-control and view storm-control
configuration information. A traffic storm is a condition that occurs when incoming packets flood
the LAN, which creates performance degradation in the network. The Storm-Control feature
protects against this condition.
The 7000 series provides broadcast, multicast, and unicast story recovery for individual
inter
faces. Unicast Storm-Control protects against traffic whose MAC addresses are not known
by the system. For broadcast, multicast, and unicast storm-control, if the rate of traffic
ingressing on an interface increases beyond the configured threshold for that type, the traffic is
dropped.
To configure storm-control, you will enable the feature for all interfaces or for individual
int
er
faces, and you will set the threshold (storm-control level) beyond which the broadcast,
Format no dot1x supplicant timeout held-period
Mode Interface Config
Default 30 seconds
Format dot1x supplicant timeout auth-period <1-65535>
Mode Interface Config
Format no dot1x supplicant timeout auth-period
Mode Interface Config
Format dot1x supplicant user <user>
Mode Interface Config