NETGEAR ProSAFE M7100-24X - Show Mail-Server Config

Utility Commands
400
ProSAFE M7100 Managed Switches
port
Use this command to configure the TCP port to use for communication with the SMTP server.
The recommended port for TLSv1 is 465, and for no security (that is, none) it is 25. However,
any nonstandard port in the range 1–65,535 is also allowed.
username
Use this command to configure the login ID that the switch uses to authenticate with the SMTP
server.
password
Use this command to configure the password that the switch uses to authenticate with the SMTP
server.
show mail-server config
Use this command to display information about the email alert configuration.
Default 25
Format port <1–65535>
Mode Mail Server Config
Default admin
Format username <name>
Mode Mail Server Config
Format password <password>
Mode Mail Server Config
Format show mail-server {<ip-address> | <hostname> | all} config
Mode Privileged EXEC
Term Definition
No of mail servers
configur
ed
The number of SMTP servers configured on the switch.
Email Alert Mail
Serv
er Address
The IPv4/IPv6 address or DNS hostname of the configured SMTP server.
Email Alert Mail
Serv
er Port
The TCP port the switch uses to send email to the SMTP server.
Email Alert
Security P
rotocol
The security protocol (TLS or none) the switch uses to authenticate with the SMTP server.