NETGEAR ProSAFE M7100-24X - Show Ip Interface Brief

Routing Commands
187
ProSAFE M7100 Managed Switches
The following shows example CLI display output for the command.
(Switch) >show ip interface 0/2
Routing Interface Status....................... Down
Method......................................... None
Routing Mode................................... Disable
Administrative Mode............................ Enable
Forward Net Directed Broadcasts................ Disable
Proxy ARP...................................... Enable
Local Proxy ARP................................ Disable
Active State................................... Inactive
Link Speed Data Rate........................... Inactive
MAC address.................................... 02:14:6C:FF:00:DE
Encapsulation Type............................. Ethernet
IP MTU......................................... 1500
Bandwidth...................................... 100000 kbps
Destination Unreachables....................... Enabled
ICMP Redirects................................. Disabled
show ip interface brief
This command displays summary information about IP configuration settings for all ports in the
router.
Format show ip interface brief
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes.
State Routing operational state of the interface.
IP Address The IP address of the routing interface in 32-bit dotted decimal format.
IP Mask The IP mask of the routing interface in 32-bit dotted decimal format.
Netdir Bcast Indicates if IP forwards net-directed broadcasts on this interface. Possible values are Enable
or Disable.
MultiCast Fwd The multicast forwarding administrative mode on the interface. Possible values are Enable or
Disable.
Method Shows whether the IP address was configured manually or acquired from a DHCP server.