NETGEAR ProSAFE M7100-24X - Spanning-Tree Edgeport; Spanning-Tree Forceversion

Switching Commands
34
ProSAFE M7100 Managed Switches
spanning-tree edgeport
This command specifies that this port is an edge port within the Common and Internal Spanning
Tree. This allows this port to transition to Forwarding State without delay.
no spanning-tree edgeport
This command specifies that this port is not an edge port within the Common and Internal
Spanning Tree.
spanning-tree forceversion
This command sets the Force Protocol Version parameter to a new value.
Use 802.1d to specify that the switch transmits ST BPDUs rather than MST BPDUs (IEEE 802.1d
functionalit
y supported).
Use 802.1s to specify that the switch transmits MST BPDUs (IEEE 802.1s functionality
supported).
Use 802.1w to specify that the switch transmits RST BPDUs rather than MST BPDUs (IEEE
802.1w functionality supported).
no spanning-tree forceversion
This command sets the Force Protocol Version parameter to the default value.
Default
enabled
Format spanning-tree edgeport
Mode Interface Config
Format no spanning-tree edgeport
Mode Interface Config
Default 802.1s
Format spanning-tree forceversion {802.1d | 802.1s | 802.1w}
Mode Global Config
Format no spanning-tree forceversion
Mode Global Config