Quality of Service (QoS) Commands
265
ProSAFE M7100 Managed Switches
show access-lists
This command displays IP ACLs, IPv6 ACLs, and MAC access control lists information for a
designated interface and direction.
IPv6 Access Control List (ACL) Commands
This section describes the commands you use to configure IPv6 ACL settings. IPv6 ACLs ensure
that only authorized users have access to specific resources and block any unwarranted attempts
to reach network resources.
The following rules apply to IPv6 ACLs:
• The maximum number of ACLs you create is 100, regardless of type.
• The system supports only Ethernet II frame types.
• The maximum number of rules per IPv6 ACL is har
dware-dependent.
ipv6 access-list
This command creates an IPv6 access control list (ACL) identified by <name>, consisting of
classification fields defined for the IP header of an IPv6 frame. The <name> parameter is a
case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IPv6 access
list.
If an IPv6 ACL by this name exists, this command enters IPv6-Access-List config mode to allow
updating the exis
ting IPv6 ACL.
Note: The CLI mode changes to IPv6-Access-List Config mode when you
successfully execute this command.
Format show access-lists interface <slot/port> [in | out]
Mode Privileged EXEC
Term Definition
ACL Type Type of access list (IP, IPv6, or MAC).
ACL ID Access List name for a MAC or IPv6 access list or the numeric identifier for an IP access list.
Sequence
Number
An optional sequence number might be specified to indicate the order of this access list
r
elativ
e to other access lists already assigned to this interface and direction. A lower number
indicates higher precedence order. If a sequence number is already in use for this interface
and direction, the specified access list replaces the currently attached access list using that
sequence number. If the sequence number is not specified by the user, a sequence number
that is one greater than the highest sequence number currently in use for this interface and
direction is used. Valid range is (1–4,294,967,295).
To Next Page
Loading...
Need help?
General