Management Commands
545
ProSAFE M7100 Managed Switches
snmp-server enable traps linkmode
Use this command to enable Link Up/Down traps for the entire switch. When enabled, link traps
are sent only if the Link Trap flag setting associated with the port is enabled. For more
information, see snmp trap link-status on page 548
no snmp-server enable traps linkmode
Use this command to disable Link Up/Down traps for the entire switch.
snmp-server enable traps multiusers
Use this command to enable Multiple User traps. When the traps are enabled, a Multiple User Trap
is sent when a user logs in to the terminal interface (EIA 232 or Telnet) and there is an existing
terminal interface session.
no snmp-server enable traps multiusers
Use this command to disable Multiple User traps.
snmp-server enable traps stpmode
Use this command to enable sending new root traps and topology change notification traps.
Default enabled
Format snmp-server enable traps linkmode
Mode Global Config
Format no snmp-server enable traps linkmode
Mode Global Config
Default enabled
Format snmp-server enable traps multiusers
Mode Global Config
Format no snmp-server enable traps multiusers
Mode Global Config
Default enabled
Format snmp-server enable traps stpmode
Mode Global Config
To Next Page
Loading...
Need help?
General