NETGEAR ProSAFE M7100-24X - Show Dhcp L2 Relay Vlan; Show Dhcp L2 Relay Agent-Option Vlan

Switching Commands
108
ProSAFE M7100 Managed Switches
The following CLI output is an example of the command output.
(switch) #show dhcp l2relay stats interface all DHCP L2 Relay is Enabled.
Interface UntrustedServer UntrustedClient TrustedServer TrustedClient
MsgsWithOpt82 MsgsWithOpt82 MsgsWithoutOpt82 MsgsWithoutOpt82
--------- --------------- --------------- ---------------- --------------
0/1 0 0 0 0
0/2 0 0 3 7
0/3 0 0 0 0
0/4 0 12 0 0
0/5 0 0 0 0
0/6 3 0 0 0
0/7 0 0 0 0
0/8 0 0 0 0
0/9 0 0 0 0
show dhcp l2relay agent-option vlan
Use this command to display the DHCP L2 Relay Option-82 configuration that is specific to
VLANs.
The following CLI output is an example of the command output.
(switch) #show dhcp l2relay agent-option vlan 5-10
DHCP L2 Relay is Enabled.
VLAN Id L2 Relay CircuitId RemoteId
--------- ---------- ----------- ------------
5 Enabled Enabled --NULL—
6 Enabled Enabled netgear
7 Enabled Disabled --NULL—
8 Enabled Disabled --NULL—
9 Enabled Disabled --NULL—
10 Enabled Disabled --NULL--
show dhcp l2relay vlan
Use this command to display the DHCP configuration that is specific to VLANs. For the
<vlan-list> parameter, enter one or more VLAN IDs in the range of 1 to 4093. Use a dash (-)
to specify a range or a comma(,) to separate VLAN IDs in a list. Spaces and zeros are not
permitted.
Format show dhcp l2relay agent-option vlan <vlan-range>
Mode Privileged EXEC
Format show dhcp l2relay vlan <vlan-list>
Mode Privileged EXEC