NETGEAR ProSAFE M7100-24X - Spanning-Tree Transmit; Spanning-Tree Max-Age; Spanning-Tree Max-Hops

Switching Commands
36
ProSAFE M7100 Managed Switches
no spanning-tree tcnguard
This command
disables the propagation of received topology change notifications and topology
changes to other ports.
spanning-tree transmit
This command specifies the bridge transmit hold count parameter, which is a number from 1 to
10.
spanning-tree max-age
This command sets the Bridge Max Age parameter to a new value for the Common and Internal
Spanning Tree. The max-age value is in seconds within a range of 6–40, with the value being less
than or equal to 2 x (Bridge Forward Delay - 1).
no spanning-tree max-age
This command sets the Bridge Max Age parameter for the Common and Internal Spanning Tree to
the default v
alue.
spanning-tree max-hops
This command sets the MSTP Max Hops parameter to a new value for the Common and Internal
Spanning Tree. The max-hops value is a range from 6 to 40.
Format no spanning-tree tcnguard
Mode Interface Config
Default
6
Format spanning-tree transmit <hold-count>
Mode Global Config
Default 20
Format spanning-tree max-age <6-40>
Mode Global Config
Format no spanning-tree max-age
Mode Global Config
Default 20
Format spanning-tree max-hops <1-127>
Mode Global Config