NETGEAR ProSAFE M7100-24X - Show Ip Dhcp Conflict

Utility Commands
434
ProSAFE M7100 Managed Switches
Message Received:
Message Sent:
show ip dhcp conflict
This command displays address conflicts logged by the DHCP Server. If no IP address is specified,
all the conflicting addresses are displayed.
Message Definition
DHCP DISCOVER The number of DHCPDISCOVER messages the server has received.
DHCP REQUEST The number of DHCPREQUEST messages the server has received.
DHCP DECLINE The number of DHCPDECLINE messages the server has received.
DHCP RELEASE The number of DHCPRELEASE messages the server has received.
DHCP INFORM The number of DHCPINFORM messages the server has received.
Message Definition
DHCP OFFER The number of DHCPOFFER messages the server sent.
DHCP ACK The number of DHCPACK messages the server sent.
DHCP NACK The number of DHCPNACK messages the server sent.
Format show ip dhcp conflict [<ip-address>]
Modes • P
rivileged EXEC
• User EXEC
Term Definition
IP address The IP address of the host as recorded on the DHCP server.
Reporting Host
Hardw
are
Address
The hardware address of the host that reported the conflict.
Detection
Me
thod
The manner in which the IP address of the hosts were found on the DHCP Server.
Detection time The time when the conflict was found.