Switching Commands
135
ProSAFE M7100 Managed Switches
no set mld querier election participate
Use this command to set the snooping querier not to participate in querier election, but go into a
non-querier mode as soon as it discov
ers the presence of another querier in the same VLAN.
show mldsnooping querier
Use this command to display MLD Snooping Querier information. Configured information is
displayed whether or not MLD Snooping Querier is enabled.
When the optional arguments <vlandid> are no
t used, the command displays the following
information.
When you specify a value for <vlandid>, the following inf
ormation appears.
Format no set mld querier election participate
Mode VLAN Config
Format show mldsnooping querier [{detail | vlan <vlanid>}]
Mode Privileged EXEC
Field Description
Admin Mode Indicates whether or not MLD Snooping Querier is active on the switch.
Admin Version Indicates the version of MLD that will be used while sending out the queries. This is
default
ed to MLD v1 and it cannot be changed.
Querier Address Shows the IP address which will be used in the IPv6 header while sending out MLD queries.
It can be c
onfigured using the appropriate command.
Query Interval Shows the amount of time in seconds that a Snooping Querier waits before sending out the
periodic general quer
y.
Querier Timeout Displays the amount of time to wait in the Non-Querier operational state before moving to
a Querier st
ate.
Field Description
VLAN Admin Mode Indicates whether MLD Snooping Querier is active on the VLAN.
VLAN Operational
St
ate
Indicates whether MLD Snooping Querier is in “Querier” or “Non-Querier” state. When the
switch is in Querier state, it will send out periodic general queries. When in Non-Querier
state, it will wait for moving to Querier state and does not send out any queries.
Operational Max
R
esponse T
ime
Indicates the time to wait before removing a Leave from a host upon receiving a Leave
request. This value is calculated dynamically from the Queries received from the network.
If the Snooping Switch is in Querier state, then it is equal to the configured value.
Querier Election
P
ar
ticipate
Indicates whether the MLD Snooping Querier participates in querier election if it discovers
the presence of a querier in the VLAN.
To Next Page
Loading...
Need help?
General