NETGEAR ProSAFE M7100-24X - RADIUS Commands; Authorization Network Radius; Radius Accounting Mode

Management Commands
552
ProSAFE M7100 Managed Switches
RADIUS Commands
This section describes the commands you use to configure the switch to use a Remote
Authentication Dial-In User Service (RADIUS) server on your network for authentication and
accounting.
authorization network radius
Use this command to enable the switch to accept VLAN assignment by the radius server.
no authorization network radius
Use this command to disable the switch to accept VLAN assignment by the radius server.
radius accounting mode
Use this command to enable the RADIUS accounting function.
no radius accounting mode
Use this command to set the RADIUS accounting function to the default value (disabled).
Default disable
Format authorization network radius
Mode Global Config
Format no authorization network radius
Mode Global Config
Default disabled
Format radius accounting mode
Mode Global Config
Format no radius accounting mode
Mode Global Config