NETGEAR ProSAFE M7100-24X - Show Green-Mode (for the Switch)

Green Ethernet Commands
586
ProSAFE M7100 Managed Switches
Note: Executing clear green-mode statistics command only clears
the EEE Transmit, Receive LPI event count, LPI duration, and
Cumulative Energy Savings Estimates of the port. Other status
parameters listed in above table will remain unaffected after 'clear
green-mode statistics'.
Example:
(switch) #show green-mode 0/25
EEE Admin Mode................................. Enabled
Transmit Idle Time......................... 0
Transmit Wake Time......................... 0
Rx Low Power Idle Event Count.............. 0
Rx Low Power Idle Duration (uSec).......... 0
Tx Low Power Idle Event Count.............. 0
Tx Low Power Idle Duration (uSec).......... 0
Tw_sys_tx (usec)........................... XX
Tw_sys_tx Echo (usec)...................... XX
Tw_sys_rx (usec)........................... XX
Tw_sys_rx Echo (usec)...................... XX
Fallback Tw_sys (usec)..................... XX
Tx DLL enabled............................. Yes
Tx DLL ready............................... Yes
Rx DLL enabled............................. Yes
Rx DLL ready............................... Yes
Cumulative Energy Saving (W * H)............. XX
Time Since Counters Last Cleared............... 1 day 20 hr 47 min 34 sec
show green-mode (for the switch)
Use this command to display green-mode configuration for the whole system. The status is
shown only for the modes supported on the corresponding hardware platform whether enabled
or disabled.
Format show green-mode
Mode Privileged Exec
Term Definition
EEE Config EEE Admin Mode is enabled or disabled.
Global