NETGEAR ProSAFE M7100-24X Reference Manual

Utility Commands
449
ProSAFE M7100 Managed Switches
debug dot1x packet
Use this command to enable dot1x packet debug trace.
no debug dot1x packet
Use this command to disable dot1x packet debug trace.
debug igmpsnooping packet
This command enables tracing of IGMP Snooping packets received and transmitted by the switch.
no debug igmpsnooping packet
This command disables tracing of IGMP Snooping packets.
debug igmpsnooping packet transmit
This command enables tracing of IGMP Snooping packets transmitted by the switch. Snooping
should be enabled on the device and the interface in order to monitor packets for a particular
interface.
A sample output of the trace message is shown below.
<15> JAN 01 02:45:06 192.168.17.29-1 IGMPSNOOP[185429992]: igmp_snooping_debug.c(116) 908 %
Pkt TX - Intf: 0/20(20), Vlan_Id:1 Src_Mac: 00:03:0e:00:00:00 Dest_Mac: 01:00:5e:00:00:01
Src_IP: 9.1.1.1 Dest_IP: 225.0.0.1 Type: V2_Membership_Report Group: 225.0.0.1
Default disabled
Format debug dot1x
Mode Privileged EXEC
Format
no debug dot1x
Mode Privileged EXEC
Default disabled
Format debug igmpsnooping packet
Mode Privileged EXEC
Format no debug igmpsnooping packet
Mode Privileged EXEC
Default disabled
Format debug igmpsnooping packet transmit
Mode Privileged EXEC

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English