NETGEAR ProSAFE M7100-24X Reference Manual

Management Commands
557
ProSAFE M7100 Managed Switches
radius server retransmit
Use this command to configure the global parameter for the RADIUS client that specifies the
number of transmissions of the messages to be made before attempting the fall back server upon
unsuccessful communication with the current RADIUS authenticating server. When the maximum
number of retries are exhausted for the RADIUS accounting server and no response is received,
the client does not communicate with any other server.
no radius server retransmit
Use this command to set the value of this global parameter to the default value.
radius server timeout
Use this command to configure the global parameter for the RADIUS client that specifies the
timeout value (in seconds) after which a request must be retransmitted to the RADIUS server if
no response is received. The timeout value is an integer in the range of 1–30.
no radius server timeout
Use this command to set the timeout global parameter to the default value.
Default 4
Format radius server retransmit <retries>
Mode Global Config
Field Description
retries The maximum number of transmission attempts in the range of 1–15.
Format no radius server retransmit
Mode Global Config
Default 5
Format radius server timeout <seconds>
Mode Global Config
Field Description
retries Maximum number of transmission attempts in the range <1-30>.
Format no radius server timeout
Mode Global Config

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English