Switching Commands
115
ProSAFE M7100 Managed Switches
set igmp mrouter interface
This command configures the interface as a multicast router interface. When configured as a
multicast router interface, the interface is treated as a multicast router interface in all VLANs.
no set igmp mrouter interface
This command disables the status of the interface as a statically configured multicast router
interface.
set igmp report-suppression
Use this command to suppress the IGMP reports on a given VLAN ID. In order to optimize the
number of reports traversing the network with no added benefits, a Report Suppression
mechanism is implemented. When more than one client responds to an MGMD query for the
same Multicast Group address within the max-response-time, only the first response is
forwarded to the query and others are suppressed at the switch.
no set igmp report-suppression
Use this command to restore the system default.
set igmp header-validation
If IGMP IP header validation is enabled, then 3 fields TTL (Time To Live), ToS (Type of Service),
and Router Alert options are checked. The fields checked depend on the IGMP version. The TTL
field is validated in all the versions (IGMPv1, IGMPv2 and IGMPv3). The Router Alert field is
validated in IGMPv2 and IGMPv3. The ToS field is validated only in IGMP version3.
Default disabled
Format set igmp mrouter interface
Mode Interface Config
Format no set igmp mrouter interface
Mode Interface Config
Default Disabled
Format set igmp report-suppression <1-4093>
Mode VLAN Config
Format no set igmp report-suppression
Mode VLAN Config
To Next Page
Loading...
