NETGEAR ProSAFE M7100-24X - Set Mld Querier Timer Expiry; Set Mld Querier Election Participate; Set Mld Querier Query_Interval

Switching Commands
134
ProSAFE M7100 Managed Switches
set mld querier query_interval
Use this command to set the MLD Querier Query Interval time. This is the amount of time in
seconds that the switch waits before sending another general query.
no set mld querier query_interval
Use this command to set the MLD Querier Query Interval time to its default value.
set mld querier timer expiry
Use this command to set the MLD Querier timer expiration period. This is the time period that the
switch remains in Non-Querier mode once it discovers that there is a Multicast Querier in the
network.
no set mld querier timer expiry
Use this command to set the MLD Querier timer expiration period to its default value.
set mld querier election participate
Use this command to enable the Snooping Querier to participate in the Querier Election process
when it discovers the presence of another Querier in the VLAN. When this mode is enabled, if the
Snooping Querier finds that the other Querier’s source address is better (less) than the Snooping
Querier’s address, it stops sending periodic queries. If the Snooping Querier wins the election,
then it will continue sending periodic queries.
Default disabled
Format set mld querier query_interval <1-18000>
Mode Global Config
Format no set mld querier query_interval
Mode Global Config
Default 60 seconds
Format set mld querier timer expiry <60-300>
Mode Global Config
Format no set mld querier timer expiry
Mode Global Config
Default disabled
Format set mld querier election participate
Mode VLAN Config