NETGEAR ProSAFE M7100-24X - Dot1 X Max-Users; Dot1 X Port-Control

Security Commands
293
ProSAFE M7100 Managed Switches
no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port
will transmit an E
APOL EAP Request/Identity frame before timing out the supplicant.
dot1x max-users
Use this command to set the maximum number of clients supported on the port when
MAC-based dot1x authentication is enabled on the port. The <count> value is in the range
1–48.
no dot1x max-users
This command resets the maximum number of clients allowed per port to its default value.
dot1x port-control
This command sets the authentication mode to use on the specified port. Select
force-unauthorized to specify that the authenticator PAE unconditionally sets the
controlled port to unauthorized. Select force-authorized to specify that the authenticator
PAE unconditionally sets the controlled port to authorized. Select auto to specify that the
authenticator PAE sets the controlled port mode to reflect the outcome of the authentication
exchanges between the supplicant, authenticator, and the authentication server. If the
mac-based option is specified, MAC-based dot1x authentication is enabled on the port.
Format no dot1x max-req
Mode Interface Config
Default 48
Format dot1x max-users <count>
Mode Interface Config
Format no dot1x max-req
Mode Interface Config
Default auto
Format dot1x port-control {force-unauthorized | force-authorized | auto |
mac-based}
Mode Interface Config