Routing Commands
178
ProSAFE M7100 Managed Switches
no routing
This command disables routing for an interface.
You can view the current value for this function with the show ip brief command. The value
is labeled as “R
outing Mode.”
ip routing
This command enables the IP Router Admin Mode for the master switch.
no ip routing
This command disables the IP Router Admin Mode for the master switch.
ip address
This command configures an IP address on an interface. You can also use this command to
configure one or more secondary IP addresses on the interface. The command supports RFC
3021 and accepts using 31-bit prefixes on IPv4 point-to-point links. This command adds the
label IP address that you can view in the output of the show ip interface command.
Note: The 31-bit subnet mask is only supported on routing interface. This
feature is not supported on a network port because it acts as a host, not
a router, on the management interface.
Format no routing
Mode Interface Config
Format ip routing
Mode Global Config
Format no ip routing
Mode Global Config
Format ip address <ipaddr> {<subnetmask> | <prefix-length>} [secondary]
Mode Interface Config
To Next Page
Loading...
