Security Commands
310
ProSAFE M7100 Managed Switches
storm-control broadcast (Global)
This command enables broadcast storm recovery mode for all interfaces. If the mode is enabled,
broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the
rate of broadcast traffic will be limited to the configured threshold.
no storm-control broadcast
This command disables broadcast storm recovery mode for all interfaces.
storm-control broadcast level (Global)
This command configures the broadcast storm recovery threshold for all interfaces as a
percentage of link speed and enables broadcast storm recovery. If the mode is enabled,
broadcast storm recovery is active, and if the rate of L2 broadcast traffic ingressing on an
interface increases beyond the configured threshold, the traffic will be dropped. Therefore, the
rate of broadcast traffic will be limited to the configured threshold. This command also enables
broadcast storm recovery mode for all interfaces.
If you select the shutdown k
e
yword and the broadcast traffic increases beyond the threshold,
the interface shuts down instead of dropping packets. To bring up the interface, enter the no
shutdown command for the interface.
no storm-control broadcast level
This command sets the broadcast storm recovery threshold to the default value for all interfaces
and disables broadc
ast storm recovery.
Default disabled
Format storm-control broadcast
Mode Global Config
Format no storm-control broadcast
Mode Global Config
Default 5
Format storm-control broadcast level <0-100> [action {ratelimit | shutdown}]
Mode Global Config
Format no storm-control broadcast level
Mode Global Config
To Next Page
Loading...
